Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Talty, TX
Chimney repair in Talty usually means getting a working wood-burning system back into safe condition before the next hard freeze, not polishing a decorative fireplace nobody uses. Homes here sit on acreage, many of them run freestanding stoves or inserts through the cold months, and a flue that sat idle all summer tends to show its cracks, loose mortar and worn cap right when the first front rolls in. We travel out to Talty with the parts and the repair capability on the truck, so the problem gets fixed rather than just noted. Call (855) 974-6812 for a free estimate.
Why Talty Homes Are Different
Talty is a small, semi-rural Kaufman County community, and that shape of place changes how chimney work gets done. Lots are spread out, houses don’t sit shoulder to shoulder, and there’s no dense grid of close-built homes to work through. A sweep’s day here is drive time between properties, which is why we load the truck for repair work and not just cleaning before we head out.
The housing stock matters just as much. Talty runs a mix of newer custom and manufactured or modular homes on large lots alongside older ranch-style houses, and the fireplaces in them tend to be brick or stone. A meaningful share of homes heat with freestanding wood stoves or inserts rather than upscale masonry fireplaces, and a stove is a different animal to service than a fireplace. Stovepipe sections, baffles and connector joints all need attention a masonry flue doesn’t.
Then there’s the North Texas weather pattern. Heat and humidity hold on for months, then winter arrives sharp and short, with occasional ice storms and hard freezes. Fireplaces and stoves sit dormant through the long warm stretch and then get used hard during cold snaps. That on-off rhythm builds creosote quickly once burning resumes, and it’s why a pre-season inspection matters more here than a midwinter brush-off.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Talty Services
Two jobs bring most Talty homeowners to the phone: a flue that needs sweeping before burning season, and a dryer vent that’s been quietly loading up with lint. Both get handled in one visit when you want them to.
Chimney Sweep in Talty
A sweep in Talty is usually a working-flue job, not a cosmetic one. Stoves and inserts that ran hard through the last cold snap leave creosote on the pipe walls, and in a semi-rural setting that flue may not have been touched since the previous winter. We brush the flue, check the firebox and connector joints, and look at the cap and crown while we’re up there. Because lots are spread out here, the visit is planned to cover the whole system in one trip rather than a return for a second look. You can book a chimney sweep and know what shape the flue is in before the first freeze.
Dryer Vent Cleaning in Talty
Dryer vents in Talty homes run long in a lot of cases, because the laundry room often sits well inside a house set back on acreage. Lint builds along that whole run, and in a manufactured or modular home the duct routing can be tighter than it looks from the outside. We pull the vent apart at the connections, run the line clear, and check the exterior hood so the exhaust actually escapes. It’s fire-safety maintenance on the same footing as the chimney, and it pairs naturally with a flue cleaning. Book dryer vent cleaning and get both hazards handled on one visit.
Chimney Repair in Talty
Chimney repair in Talty comes up most often on two kinds of homes: older ranch-style houses whose brick and mortar have had decades of North Texas heat-and-freeze cycles, and newer manufactured or modular homes where the stove or insert was added and the venting needs to actually match the appliance. The sharp, short winters and occasional hard freezes here put a flue through real expansion and contraction, and water that gets in through a failed crown or flashing does quiet damage between burning seasons. We handle Chimney Repair in-house, so the issue we find is the issue we fix, with liners and materials from trade suppliers like DuraFlex and Olympia Chimney rather than a big-box substitute. Nothing gets recommended without photo evidence you can look at yourself.
Chimney Crown Repair
Signs you need it
Look for a cracked, flaking or visibly sloping crown at the top of the chimney, or water staining on the ceiling or firebox after a hard rain.
What it costs in Talty
Crown repair typically runs $350 to $700, with a full crown rebuild at the higher end, and the written estimate sets the final figure.
How we do it
We clear the damaged material back to sound masonry, form the correct slope so water sheds away from the flue, and finish with a repair mix rated for the job.
Chimney Liner Installation
Signs you need it
A cracked or spalling clay liner, gaps at the joints, or a stove that backs smoke into the room points to a liner that’s no longer doing its job.
What it costs in Talty
Liner installation typically falls between $2,400 and $5,500 depending on flue size, appliance and liner type, and the written estimate sets the final price.
How we do it
We size the liner to the appliance, insulate and drop it into the flue, connect it to the stove or fireplace, and confirm the fit and draft before we leave.
Chimney Cap Installation
Signs you need it
An open flue with no cap, or one that lets rain, birds or squirrels straight in, is the usual reason homeowners call about this one.
What it costs in Talty
Cap installation usually runs $180 to $450, depending on the flue size and whether a custom cap is needed, and the written estimate sets the final number.
How we do it
We measure the flue opening, fit a stainless cap sized to it, and secure the legs or mounting so it holds through North Texas wind.
Chimney Flashing Repair
Signs you need it
Rust streaks on the flashing, a gap where the roof meets the chimney, or damp patches inside after a storm all point to flashing that’s failed.
What it costs in Talty
Flashing repair typically costs $300 to $650, with a full flashing replacement at the upper end, and the written estimate sets the final figure.
How we do it
We pull the old flashing and sealant, reset new flashing into the chimney and roof, and seal the joints so water runs off instead of working its way in.
What Chimney Repair Costs in Talty
These ranges cover the repair work we see most in Talty. They’re typical estimates, not a quote for your house.
| Item | Typical range in Talty |
|---|---|
| Chimney crown repair | $350 – $700 |
| Chimney liner installation | $2,400 – $5,500 |
| Chimney cap installation | $180 – $450 |
Do I really need a new liner in my Talty home?
Only if the flue shows real damage: cracks through the clay, gaps at the joints, or a stove that doesn’t draft properly. We show you the camera footage and tell you plainly when a liner can wait. Call (855) 974-6812 for an exact quote – estimates are free.
Can you fix a chimney crown or flashing before winter?
Yes, and it’s the right time to do it. Getting the crown and flashing sound before the freezes keeps water out of masonry that would otherwise crack through another cycle. Call (855) 974-6812 to book an inspection and estimate.
Brands We Service in Talty
We stock and install trade-grade components from Olympia Chimney, DuraFlex, Famco and Copperfield, so common repair parts are usually on the truck rather than ordered and waited on. When a specific piece has to come in, we’ll tell you the timeline up front. You can see the full range on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Talty, TX
| Service | Typical range in Talty |
|---|---|
| Chimney sweep | $150 – $300 |
| Dryer vent cleaning | $120 – $250 |
| Chimney crown repair | $350 – $700 |
| Chimney liner installation | $2,400 – $5,500 |
| Chimney cap installation | $180 – $450 |
| Chimney flashing repair | $300 – $650 |
What pushes the price up in Talty is the same thing that makes the work necessary: heavily used stoves and inserts load creosote faster, and masonry on older ranch homes often needs more than a single repair once water has been getting in. We give you the price in writing before any work starts, so the number on the estimate is the number you pay.
Neighborhoods We Serve in Tally
We cover Talty from one side to the other, and because the lots are large and spread out, a visit is scheduled by area rather than by street. Whether your place sits off a county road on acreage or in one of the smaller pockets of homes closer to the main routes, we plan the trip so it’s a single stop. The neighborhoods and areas we most often work in:
- Homes along the county road corridors on the north side of Talty
- Acreage properties set back off the main routes
- Newer custom builds on large lots
- Older ranch-style homes nearer the center of town
- Manufactured and modular homes on acreage
We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Service Area – Cities Near Talty
Talty sits in Kaufman County with a handful of other communities close by, and we cover all of them on the same travel routes. If your home is just outside Talty, we can still get to you without a long wait. We regularly work in Garland, TX, McLendon-Chisholm, TX, Crandall, TX and Farmersville, TX, and we can schedule a Talty-area call alongside any of them. Tell us where you are when you call and we’ll book it into the nearest run.
Serving Talty, TX – Our Local Coverage Area
We serve Talty and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Talty
Scheduling depends on the season and how far out the run is, and we’ll tell you the next opening when you call. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday, gets a technician to you as soon as a slot opens.
Repair work on an existing chimney usually doesn’t need a permit, but a new liner, a stove install or structural changes can. Check with Kaufman County or the city before starting, and ask your HOA if your community has one. We’ll tell you what we’re doing so you can confirm.
Yes. We work across Talty and the surrounding Kaufman County communities, including the acreage properties and smaller pockets of homes on the outer roads. If you’re not sure whether your address falls in our run, call (855) 974-6812 and we’ll confirm.
Ready to get your chimney or dryer vent in safe working order? Call (855) 974-6812 for a free estimate. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday, brings a technician out to look at your system and give you a written price before any work begins. Dayspring Chimney Sweep handles cleaning and repair under one roof, so the fix matches what we found.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Talty Customers Say
"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Andres Guzman"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
- Elena Martinez"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
- Danielle Novak